8051 Microcontroller: Serial Data Transmission

For 8051 Microcontroller Serial Communication basic go to ___https://youtu.be/5Dn69HZ_w7c For the case of Serial Data transmission in 8051 microcontroller, at first data should be framed and for framing the data we may use standard protocol, say number of bit in data is 8, one start bit(logic 0) one stop bit (logic 1). For transmitting and receiving the data, Baud rate of Receiver and transmitter should be same. For setting the Baud rate we must uses the Timer. We must set the proper value of TMOD, we must set initial value of Timer and then Timer should be run. In another video tutorial I have discussed how to perform those all. Now in this video tutorial we have discussed about the construction and function of UART where we can understand the function of SBUF register which is one of the main register for Receiving and Transmitting data. SCON register is used to set the mode of data communication. Here I have discussed about function of each bit of SCON register. Also we have discussed how to write program to transmit the data For more helpful video go to......... https://www.youtube.com/channel/UCNn_5QdLYzIgyj83Kz_3aKQ -------------------------------------------------------------------------------- Dear visitors, Put your constructive comments to improve the channel’s quality. Do unlimited Like, Share, Subscribe. This will cost nothing from your side but it will help this channel to get a strong platform. The more subscribers I will get, the channel will move forward, the better and more helpful content I will publish here for you. Subscribe. Subscribe. Subscribe. @silenceandprogress