Building a Keezer

They say you haven't lived until you've served your own draft beer on tap in your personal boozer. For this you'll need a keezer and that's exactly what Ed and Andrew build in this video using an old chest freezer. 🍺 EQUIPMENT (from regulator to tap) 🍺 -Regulator https://www.themaltmiller.co.uk/product/micromatic-co2-regulator/?v=79cba1185463 -Beer Pipe 3/8" https://a1barstuff.co.uk/keg-beer-line-3.html -Manifolds https://brewkegtap.co.uk/products/co2-gas-manifold-with-mfl-john-guest-push-fits -Keg Quick Disconnects https://amzn.eu/d/hOZNo0k -John Guest Fittings for Keg Quick Disconnects https://brewkegtap.co.uk/products/john-guest-speedfit-3-8-1-4-ffl?_pos=12&_sid=02b2c197b&_ss=r -John Guest Fittings for Pipe to Tap https://brewkegtap.co.uk/products/john-guest-speedfit-3-8-to-3-16-inline-reducer?_pos=2&_sid=02b2c197b&_ss=r -Beer Pipe 3/16" https://a1barstuff.co.uk/keg-beer-line-1.html -John Guest Fittings for Tap Shanks https://brewkegtap.co.uk/products/john-guest-3-8-stem-elbow-3-16-reducer -Tap Shanks https://www.themaltmiller.co.uk/product/stainless-steel-short-shank/?v=79cba1185463 -Taps https://brew2bottle.co.uk/products/stainless-steel-intertap-handle -Inkbird https://www.brewbrosshop.co.uk/products/inkbird-itc-308-temperature-controller Notes: -we didn't use John Guest fittings to attach pipes to the manifolds, we soaked the ends in hot water to make them more malleable so they fit snugly over the barbs -in the UK, the John Guest fittings were cheaper in bulk from https://tvsbeverage.msys-epc.com/ -for our 8 tap setup we used 3/16" pipe x 15m and 3/8" x 12m ❄️ KEEZER MATERIALS ❄️ -old chest freezer -CLS 4in x 2in (2 x 2.4m lengths) -corner brace x 8 -screws -Gripfill Solvent-free -standard 15mm heating pipe insulation (which we will replace in due course) -shortly after filming we added a couple of chains hooked on the wall to keep the gas cylinders upright -a few tools (Ed and Andrew), some patience and beers