DIY Remote Starter Part 2: Testing Wires!

**Timeline below if you would like to skip to a specific section** Before I go ahead and start building my DIY remote starter, I need to make sure that the wire I would like to interface to actually exist and are accessible in my car. In this video I will be testing the functions of wires against a wire color code sheet that I made. Not everything matched my sheet, so it's a good thing I checked before I started building! 0:00 - Intro 0:50 - Taking a part dash 1:03 - Key cylinder wires 5:25 - Parking light wire 6:15 - Neutral safety switch wire 7:19 - Lock signal 9:25 - Break light wire 10:01 - Remote start location 10:23 - Service switch location 10:47 - Hood pin switch location 11:31 - Subscriber shout out! 11:39 - Outro Materials Used: - Wire Color Code Chart Sheet (Free!...unless you wanna pay, but for this you really don't have to) https://sellfy.com/p/0KWn/ Tools Used: - Modern test light - Wire piercing tools - Phillips screwdriver - Pick tool - Panel popper - Plastic pry bar Related videos: - Part 1: Planning it out - https://www.youtube.com/watch?v=zLmUFPVpKPo