DYNAMIXEL Quick Start Guide with RC protocols

This video will be covering how to set up DYNAMIXEL to communicate with the RC controller (Futaba T10J) under S.BUS protocol, and move the DYNAMIXEL through the RC controller within just two MINUTES. The RC protocol is mainly used with the RC servos to communicate wirelessly (Even in the air) via a receiver for multicopter, drones and RC cars. As the RC market has been very popular for the film industry, transportation and so on, we are happy to introduce our first DYNAMIXEL with S.BUS, I.BUS, and RC-PWM protocols types via the DYNAMIXEL Quick Start series !! Thank you for watching :) * Supported DYNAMIXELs for RC protocols: XL330 series * Available RC protocols: S.BUS, I.BUS and RC-PWM. * The current S.BUS and i.BUS protocol types in DYNAMIXEL are experimental protocol types, so that it may not be fully support all the features of S.BUS and i.BUS or not be compatible with 3rd party devices. 🏪 Components & e-shop - XL330-M288-T : https://bit.ly/3e8nRev - DYNAMIXEL Starter Set : https://bit.ly/3bejAEC - Futaba T10J - Futaba R3008SB - 3.7V Li-Po battery & 3 pins hub board * U2D2, U2D2 PHB and SMPS are included in the DYNAMIXEL Starter Set. * ⚠ 12V SMPS is not used with XL330 (Operating Range: 3.7 to 6V) 🔨 Software & Tools - DYNAMIXEL Wizard 2.0 : https://bit.ly/38bqIQm #QuickStart #How​to #DYNAMIXEL​ #RC #Protocols #Futaba #ibus #sbus Chapters: 0:00 Overview 0:10 Summary for DYNAMIXEL setup and assembly with RC receiver 0:17 Assembly of DYNAMIXEL Starter Set with DYNAMIXEL 0:31 PC connect to change the protocol type to S.BUS 1:12 Hardware setup with RC receiver and DYNAMIXEL 1:00 PC Setup: Install DYNAMIXEL SDK 1:35 Run DYNAMIXEL