E3D Toolchanger - Configuration #04 - Adjusting Hemera Tools

In this video of the configuration-series of the toolchanger, I am going to mount the four Hemera tools in the E3D-ToolChanger and adjust the needed settings. Most of the needed steps are explained in detail in tutorials before, but I will show you the steps needed to get Hemera-Tools going. I made a well-engineered fan duct for the Hemera! Check it out: https://rene-jurack.de/well-engineered-hemera-fan-duct-2/ 🤝Please support me:🤝 buy a ToolChanger: https://geni.us/ToolChanger Patreon: https://www.patreon.com/renejurack PayPal: https://www.paypal.me/renejurack ⚙️🛠Additional parts and tools used (affiliates): WEIDMÜLLER Stripax: https://geni.us/stripax KNIPEX pliers: https://geni.us/KnipexPliers WERA L-key color: https://geni.us/WeraLkeys WERA micro hex screwdriver set: https://geni.us/WeraMicro USB microscope: https://geni.us/USB_microscope All my designs & files at https://www.rene-jurack.de fan duct also at: https://cults3d.com/en/3d-model/tool/well-engineered-hemera-fan-duct E3D-Wiki: https://e3d-online.dozuki.com/c/ToolChanger_and_Motion_System_Assembly_Guides Facebook-Group about Toolchangers: https://www.facebook.com/groups/237615240416855 E3D-Discord with TC-Channels: https://discord.gg/RpT6Cq7dyP 00:00 - Introduction 00:39 - Intro 00:49 - mounting Hemera-Tools 01:28 - handling tools carefully 02:56 - initial setup 03:27 - adjusting Z-offset 03:51 - adjusting XY-offset 04:25 - outro & credits Music by Epidemic Sound https://www.epidemicsound.com/referral/nxel1m/