Easy RC Hinges from Milk Containers

Easy RC Hinges from Milk Containers In this video I will demonstrate a very easy method to use the tough plastic from normal milk containers as hinges for your RC model aircraft. The plastic is cut away from the milk container. Sand round the edges of each control surface such that they do not bind during movement. Use an X-acto knife to cut a slot in both of the control surfaces. Use 5 minute epoxy to glue the hinges in place, trying to remove any excess glue. Repeat with the other control surface. Be sure to keep the surface flexing while the glue dries to prevent the hinge from being rigid. The milk container hinges are a simple and low cost way to make effective RC model airplane control surfaces. Here is a link to my YouTube Channel: https://www.youtube.com/c/TimMcKay56 Many thanks in advance for a post of this video on Facebook, it truly helps the channel a lot! Regards, Tim Aeronca C-3: https://youtu.be/6Fgy7EqxsZ0 Foam board F-22: https://youtu.be/Ya9bT2I4-AY Chapters 00:00 - Intro 00:20 - Hinge overview 01:28 - Milk container hinges 01:54 - Hinge installation 02:13 - Glue considerations 02:57 - Hinge demonstration