Honda Talon COM Install

This is a very detailed install video for the Honda Talon. It will go in depth on everything you need to know about how to install TheCOM Stereo intercom and radio. Chapters: 00:00 Introduction 00:51 ACC Power wire 01:35 Kick Panel Removal 03:25 Radio Plate Screws 04:10 Coax & Power Wire Run 08:17 Cushion Clamps & Intercom Install 10:24 Jumper Wire 11:46 Tech Tips 12:33 Headset Wires 13:57 Hole Mount PTT's 16:35 Power Wiring / Relay / Noise Filter 19:26 Battery Connection 19:50 Radio Faceplate Install 20:51 Antenna Ground Wire Noise - Removed on this install 21:11 Headset Rack Install 22:26 Final Look We ended up not using the antenna ground wire on this install because it was introducing noise into the system. We have seen this on other Honda's and Yamaha's. If the intercom was installed in the upper compartment where the switch panel was I would recommend running the headset wires to the "A" pillars and then up and over the shoulders. Alternatively you could run down the center tunnel and out the back. For the link on how to wire the relay switch see the link below: https://utvcom.com/wp-content/uploads/2021/09/How-to-wire-a-relay-to-The-COM.pdf Here is the video of the relay switch: https://youtu.be/ggTZQqtjzv4 see more at: https://utvcom.com/ See our new customer training videos at: https://utvcom.com/new_customer_training/ See our install examples at: https://utvcom.com/installation-examples/ See our research articles at: https://utvcom.com/blog/