How to clone fixed code remote controls (side by side)

Follow these easy steps to program your remote • You need to erase the remote first : 1. Click and Hold 1 and 2 buttons together - Led will flash 3 times 2. Keep holding button 1, push button 2 3 times, Led will start Flashing Non-Stop. Next you need to clone your original remote : a. Put both remotes Into back to Back position or side-by-side. Make sure they have direct contact , touching, push a bit to make them touch each other harder. b: Click and hold 1 button on your original remote and 1 button on your clone remote. Keep holding until led will make : 2 blinks - 3 blinks - Steady = Successfully cloned, only after the light goes into steady. • If for some reason the clone does not go further then 2 blinks , it means the signal does not go through, please shift the remote slowly up and down, very slowly until you get the point where it will go through. • Note: you don't need an access to you control board or receiver!!!