HOW TO | CORRECTLY WIRE A REVERSE CAMERA

DISCLAIMER: A “star” next to the product denotes an affiliate link. If you buy from the affiliate store using this link, I may get a small commission on the sale. Thank you for your continued support Ask me anything: https://chatgpt.com/g/g-686922ce8b8c8191b70dd97f98946c5d-reverse-camera-wiring-helper Top 10 Reverse Camera Installation FAQ: https://buymeacoffee.com/autosngizmos/top10-issues-when-installing-a-reverse-camera - - - - - - - - - - - - - - - - - - - - - - - - - - - 🛒 PRODUCTS FEATURED IN THIS VIDEO: - - - - - - - - - - - - - - - - - - - - - - - - - - - AMAZON ⭐️ Reverse Camera for C200K W203 https://amzn.to/3E2NXi6 ⭐️ MB C200 W203 Android Headunit https://amzn.to/40q3Mal ⭐️ Recommended accessories for C200K W203 https://amzn.to/4e7AhPq ⭐️ Automotive Electronic DIY Essentials https://amzn.to/40iij9j ALIEXPRESS ⭐️ Android Headunit for MB C200K W203 OPTION 1: 8” Screen w/ wired ACP and AA https://tidd.ly/3yPeEjz OPTION 2: 7” Screen w/ wireless ACP and wired AA https://s.click.aliexpress.com/e/_Af3Hfr ⭐️4.3" Screen https://s.click.aliexpress.com/e/_c3mDK8jn - - - - - - - - - - - - - - - - - - - - - - - - - - - 🎥 RELATED VIDEO: - - - - - - - - - - - - - - - - - - - - - - - - - - - Reverse Camera Installation Guide https://youtu.be/uf7iFzxUnoA In this related video, you will see me apply the same technique where I used the brown wire from the CANBUS decoder that outputs 12v and send that through the red wire of the video cable. And finally, I used the ground point underneath the carpet trim to connect the reverse camera system to ground. - - - - - - - - - - - - - - - - - - - - - - - - - - - About this video - - - - - - - - - - - - - - - - - - - - - - - - - - - This is a video to show you two ways to connect a #ReverseCamera into your existing #Android #Headunit. The typical way others do is to feed the camera with 12v signal coming from the car’s reverse tail light. But my preferred way is to connect one end of the red wire coming out of the RCA video connector into the “Reverse” trigger on the headunit as a means to power up the reverse camera. There is no messing around with light bulbs that may cause a CANBUS error.