Knife making - Hand made frame lock

I have wanted to make a 100% hand made liner lock / frame lock knife for a very long time. I Have made some in the past, but what I did not like about them, was the fact that I had to use purchased hardware for pivot and screws. I finally got around to getting the tools needed for treading. Now I can make my own pivot and screws. All though it’s a slightly rough way of doing it, I am still very happy with the result. In this video I get to play around with new technics, and materials new to me. Like Titanium. I hope you enjoy. WebShop: inmyshed.net 1. Checkering File - https://amzn.to/3Sn8i4Q 2. Files I like - https://amzn.to/3YCbo6D and https://amzn.to/3ZxZko4 3. Tetra Gun Liquid Blue - https://amzn.to/3xH2zgR 4. 123 Blocks I use - https://amzn.to/3UgktkM 5. Hardness tester file set - https://amzn.to/3mg3q5T 6. Optical center punch - https://amzn.to/43DQ2ue These are amazon affiliate links. FULL DISCLOSURE I earn from qualifying purchases. Heat treat info The blade 1. Preheated at 1472F / 800c for 15m 2. Held at 1940F / 1060c for 12m 3. Plate quenched about 2m 4. Put in regular freezer for 60m 5. Tempered at 437F / 205C 2x2 H. Air cooled in between The Pocket clip 1. Preheated at 1472F / 800c for 15m 2. Held at 1940F / 1060c for 16m 3. Plate quenched about 2m 4. Air cooled to room temperature. 5. Tempered at 1099,4F / 593C for 1H 7. Plate quenched 0:00 Info on the build 1:41 Drilling and grinding blade and liners 3:01 Cutting out the lock bar 3:15 Making the stop pin slide 3:44 Making washers 4:04 Test fit and back spacer 4:08 Grinding bevels 4:42 Checkering and stamping 6:00 Heat treat 6:19 Clean up after HT and temper 7:20 Clean up liners 8:36 Pocket clip 9:56 Making screws and pivot 11:30 Anodizing 11:44 The result