Precise Point Positioning (PPP) on Unicore GNSS Modules: Step-by-Step Setup

In this video, I explain what Precise Point Positioning (PPP) is and how to enable it on the Unicore UM980/UM982 GNSS module. I guide you step-by-step through setting up PPP on the UM98X, covering commands, configurations, and enabling specific signal groups like B2b-PPP and E6-HAS. I also discuss convergence times and the accuracy of PPP. While this video uses the Unicore UM980 GNSS module to demonstrate setting up the unit for PPP, it should also provide helpful hints for setting up other GNSS modules. Commands to configure PPP: FRESET (Factory reset to start with a blank sheet) CONFIG SIGNALGROUP 2 (Enable the Largest number of bands for UM980) CONFIG SIGNALGROUP 3 6 (Enable the Largest number of bands for UM982) MODE ROVER (best for moving rover) CONFIG PPP CONVERGE 10 20 (*HorSTD in cm VerSTD in cm) CONFIG PPP ENABLE B2b-PPP (*Enabled BeiDou PPP service) CONFIG PPP ENABLE E6-HAS (Enabled Galileo PPP service) PPPNAVA 10 (Get PPP status every 10 seconds) GNGGA (Output time, position, and other fix-related data) SAVECONFIG (Save Configuration into non-volatile memory) *Only enable one PPP service at a time! Links to other Vidos in this Series: RTK Playlist: https://youtube.com/playlist?list=PLlxhE8mLdQdHq4C_DjIz_UhQR9dJWjFJM&si=E7PzqSZXqBDXVjPj Intro to RTK Playlist: Achieve Centimeter Accurate GPS and Crypto Mining with Affordable Hardware: https://youtu.be/jqYMHWi4KoI Setting up a low-cost DIY RTK Base Station based on the UM980 module: https://youtu.be/hNGAsFLfFtI Setting up a UM982 GNSS Module as an RTK Rover: https://youtu.be/CfcMfGZBFmQ Low-Cost ESP32-based DIY RTK Base Station, NTRIP Server, and Crypto Miner: https://youtu.be/KGQ1xdwAq1A ESP32-based RTK Rover: https://youtu.be/0WFRUoyRmHE Low-Cost DIY Double Crypto Mining with ESP32-NTRIP-DUO: https://youtu.be/33Mu5EV7fOE Connecting an RGB LED to the ESP32 Xbee NTRIP Master: https://youtu.be/3U-OxEzS_lw ESP32 based Local RTK Network: https://youtu.be/YeuwY2A0FpM