Q CON Wall Panel #Installation

How to install #QCON #wallpanel from #SCG 1. Clean and mark the wall alignment by using a chalk tape 2. Clean Q-CON Wall Panel and move to the marked point 3. Mix thin-bed mortar and apply it on structure column 4. Lift the Wall Panel and push it to attach the column 5. Insert a foam sheet between floor and top of the Panel 6. Use lever to lift Q-CON Wall Panel until top of the panel reach the upper floor then insert a wood wedge under the panel 7. Use steel angle to fasten the panel with floors on both upper and lower side of the panel by using steel plugs and screws 8. Apply thin-bed mortar on side of the first panel then lift the next wall panel to attach and do the same as the previous steps 9. Continue install wall panels until the gap can be closed by the last panel 10. Measure the gap and cut the last panel to fit in then install it in place 11. Fill the gap under the panels with sand-cement mortar 12. Fill all gaps between each panel with thin-bed mortar, wait until the mortar dry then rub with sandpaper no.400 13. Finishing all gaps again with skim coat then rub with sandpaper no.200 Follow our other social media channels to know more #knowledge and #technical tip: - Website : https://www.zmartbuild.com/ - Facebook : https://www.facebook.com/zmartbuild/ - Pinterest : https://www.pinterest.com/ZmartBuild/ - LinkedIn : https://www.linkedin.com/in/zmartbuild/ - Twitter : https://twitter.com/zmartbuild - Instagram : https://www.instagram.com/zmartbuild/