Setting Primary Gear End Float - Classic Mini Cooper

❱❱ Supercharger Giveaway - https://merch.classicminidiy.com All purchases on the merch store enter you to win a @VMAXSCART supercharger. ❱ Patreon - https://www.patreon.com/join/classicminidiy ❱ Shop - https://merch.classicminidiy.com ❱ Seven Mini Parts - http://bit.ly/7evenmini ❱ Instagram - https://www.instagram.com/classicminidiy59/ ❱ Facebook - https://www.facebook.com/classicminidiy In today's episode we will be covering the process by which you set your Primary Gear Endfloat. An often overlooked but extremely important task that should be part of any Classic Mini engine build. ❱❱ Address for Mail Time: 6241 South Blvd #241403 Charlotte, NC 28217-4157 ❱ Parts in this Episode: 29 Tooth Primary Gear: https://cmdiy.co/29ToothPrimary Feeler Gauge: https://geni.us/RLB0w (Amazon) Retaining Ring: https://cmdiy.co/RetainingRing C-Clip: https://cmdiy.co/cClipRetainer Thrust Washers: https://cmdiy.co/ThrustWashers Thanks for watching Classic Mini DIY! Please note Classic Mini DIY assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Classic Mini DIY recommends safe practices when working with power tools, automotive lifts, lifting tools, jack stands, electrical equipment, blunt instruments, chemicals, lubricants, expensive electronics, or any other tools or equipment seen or implied in this video. Due to factors beyond the control of Classic Mini DIY, no information contained in this video shall create any express or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or the information contained in this video is the sole responsibility of the user and not Classic Mini DIY. Only attempt your own repairs if you can accept personal responsibility for the results, whether they are good or bad.