Single Mosfet - Class E - Solid State Tesla Coil

This project is sponsored by PCBWAY https://www.pcbway.com/?from=MirkoP https://www.pcbway.com/activity/anniversary10th.html This Tesla coil, although apparently simple to make, actually requires a lot of knowledge, patience and tools to set it up ideally. However, even with less experience, it can be tuned quite well with the trial and error method. With a properly adjusted device, the length of the scattered spark exceeds 20 cm. SAFETY NOTE: Please do not attempt to recreate the experiments shown on this video unless you are familiar with High Voltage Safety Techniques! Direct Current even above 60V maybe lethal, even when the AC supply voltage has been disconnected due to the stored energy in the capacitors. I have no responsibility on any hazards caused by the circuit. Be very careful. Chapters: 0:06 Short Demo 1:35 Description 3:18 Basic Parts 4:05 Driver parts 5:20 Tunning 6:49 Variac 7:10 Demonstration 8:38 Arduino Interrupter 9:20 Demonstration with Interrupter 10:20 Conclusion and Safety Note .11:33 Building Detailed instructions, schematic, and code at: https://www.hackster.io/mircemk/single-mosfet-class-e-solid-state-tesla-coil-1dd9b3 If you like my job buy me a coffee: https://ko-fi.com/mircemk If you are interested in this area, see the Playlist at: https://www.youtube.com/playlist?list=PLAxrqEdgtyUV5SriPejNitf6dWFyW8zPQ Visit my Youtube Channel for more Projects , DIY and How To Make videos: https://www.youtube.com/c/MirkoPavleskiMK/videos by mircemk SUBSCRIBE LIKE AND SHARE !!!! Thanks for your Support ! #teslacoil #nikolatesla #arduino #electronics #pcbway