Speed

Speed is easy and comfortable to operate you only have to roll the car over the Speed no ramps are needed. It's so small and low almost any car will go over begin by releasing the lifting arms and adjust the position lengthwise. Raise the lifting pads until they catch on the sill panels or rocker panels at the recommended lifting points. Raise the car to a comfortable working position if the car sill’s are too high extensions can be added to the lifting pads for even greater lifting packed. Assemble the bench mountings and chassis claps a chain attachment is available as an accessory it can be used for fast temporary anchoring the car it's important that the bolts for the bench mountings and claps are tight and in the right order. First tighten the bolt which is just the height the bench mount so that the clap goes up towards the sill panel then tighten the bolts that lock the bench mounting the bench then tighten the bolt for the chassis clap finally the bolts that marked the clap to the bench mounting. Let's take it once again first the bolt for height adjustment then the bolts that lock the bench mounting at the bench then the bolts for the chassis clap and finally the bolts the lock the clap to the bench mounting. By using this Speed check measuring tool you can quickly make a comparison measurement of the damage. Speeds adjustable working height makes disassembly work easier. When disassembly is finished we lower it in order to mount the draw a liner if we press the down button for the first position the speed stops automatically at the right height for the draw liner. Insert the drawer liner in the bracket it's important that the draw liner be inserted all the way to the stop cleat. The drawer liner can be rotated and has a good reach at the side of the car as. Use a splinter free sleaze hammer to insert the wedge that locks the draw liner in position. Position the drawer liners arm so that the damage can be pulled parallel to the draw liner. The arm is balanced and will remain in its set position mount the safety wire so the chain cannot fly off if the body clamp should suddenly let go during pulling. Connect the foot pump to the cylinder of the draw liner and pull with Speed a repair job can be done quickly and easily, which is good news for The Body Shop the car owner and the insurance company. Speeds many news smart solutions means not even small repair jobs will be profitable. With speed cycle time in your shop is reduced this means greater productivity and profitability.