Use Vectric to make a spiral table leg. Just a quick note...I used a 1/2 end mill for roughing and a 1/2 inch ball nose for finishing. That wasn't reflected in Vectric tutorial but was corrected before machining. Use at your own risk. I am NOT an expert, this is for entertainment purposes only.
In case you want to skip ahead, here are the high points:
0 - 10:24 Vectric Tutorial
10:25 - 11:46 Test Roughing Pass
11:47 - 13:11 Video Of Roughing
13:12 - 13:36 Time Lapse of roughing -- a MUST SEE
13:37 - 15:15 Finishing Tool Path
15:16 - 16:00 Finished Leg
Please Visit:
http://www.vectric.com
http://www.toolstoday.com
http://www.wagcnc.com
