Using OLED SSD 1306 on a RaspBerry PI using MyRobotLab

MyRobotLab ( http://www.myrobotlab.org ) is an Open Source software project that can be used to program robots. One of the new services is the OledSSD1306 display. It uses the i2c two wire protocol. The i2c bus is available on the Arduino and you can also use the Raspberry PI GPIO pins for i2c. Here I test the speed of the display connected to the Raspberry PI. One of my earlier videos (https://www.youtube.com/watch?v=4jXhMxEE2bI ) showed the display connected thru the Arduino. The code used can be found here: http://myrobotlab.org/service/OledSsd1306