Woody w

AN hose fitting installed with less stress.

Woody w

How to make adjusting coil slugs way less difficult.

Woody w

modulation of noise floor

Woody w

local 80m noise vs preselector

Woody w

toy cat snake does not seem to be working, just goes in circle...

Woody w

Running nut control n auto reverse, no binding.

Woody w

Testing auto-reverse on magnetic loop tuner drive motor

Woody w

Getting my. JOHNSON DESK KW UP ON MY WORK BENCH, 450#

Woody w

my outdoor solar ham shack visitors

Woody w

Diagnosing a ALS500M amp that i returned under warranty, it was sent back as no problems found.

Woody w

Restoring an invader 2000 chassis finish, with a bit of brushing and spray paint.

Woody w

An easy to make mobile work bench for working on old radios or other hobbies

Woody w

Valiant transmitter refitted and repainted

Woody w

Squirrel proof feeder.....maybe

Woody w

Valiant front panel restoration

Woody w

Increased carrier modulation on a Johnson 500 with one small part.

Woody w

Testing Johnson 500 on bench with negative plate clamp installed

Woody w

Johnson 500 repainted and refurbished, better than new.

Woody w

hex beam on a fold over mast on a tilt over tower.

Woody w

My hex beam on a stick mast for better support and fold over capabilities.

Woody w

Polishing radio knobs (Johnson radio shown) easily.

Woody w

Tilt over MAST for my diy tilt over tower -crank up mast , HEX ANTENNA.

Woody w

Mag loop trimmer capacitor to allow 40m operation.

Woody w

rig blaster audio issue on separate xmitter and receiver....boat anchor station.

Woody w

Tuning my Johnson Invader 2000 electronically with my huff- n- puff circuit.

Woody w

huff n puff oscillator stability checkout.

Woody w

Huff and puff ckt added to my INVADER 2000 for stability

Woody w

INVADER 2000 Stable operation after parts are all back together

Woody w

Tilt over hex beam on 53' crank up tilt mast i designed. part #3

Woody w

Tilt over hex beam part #2

Woody w