Revit Tutorial - Primary Pipe Support - Clamp

Part 1.7 - Piping Modeling - Revit Tutorial - Primary Support - Clamp https://www.pipeex.org/ 0:00 Introduction 0:19 Start a new generic metric model family 0:38 Add reference planes and label clamp width W 0:48 Add front view reference planes for outer edges and bolt holes 1:08 Define the gap between clamp halves as T 1:16 Create the top half clamp with a sweep 1:32 Label the bend radius as R 1:36 Define and center the main clamp diameter 2:00 Create the clamp profile and add thickness 2:22 Mirror the first half to create the second half 2:32 Check the profile and add the missing thickness dimension H 2:45 Add bolt holes 2:56 Load the lookup table 3:21 Add shared parameters like nominal diameter and description 3:33 Connect family parameters to the lookup table 3:46 Set AC as a calculated value 4:15 Add connectors and assign the primary connector 4:27 Change the category to pipe accessories 4:36 Save the family and test it in the project 4:42 Final result 4:47 Outro #Engineering #PipingEngineering #MechanicalDesign #ProcessEngineering #AutodeskPlant3D#RevitTutorial#SoftwareTutorial#IndustrialEngineering#TechnicalSkills #DIYEngineering #TutorialVideo#InnovativeEngineering #ProductivityTips #ProfessionalDevelopment #TechSavvy #EngineeringLife #CADDesign #DigitalEngineering #SkillBuilding #LearningResources