The BEST Glue for Arrow Inserts

Jake Explains the best types of Glue to use for your arrows for hunting and targets! This is a lesson that every Archer can benefit from. GO TO http://www.fetherarchery.com for more products. Get GT IMPACT here: https://fetherarchery.com/products/goat-tuff-gt-impact-rubberized-adhesive Get Coolflex here: https://fetherarchery.com/products/bohning-ferr-l-tite-cool-flex-%E2%84%A2-hot-melt-adhesive In the world of archery, where success is measured in millimeters, the tools of the trade extend beyond bows, strings, and arrows. At Fether Archery, a small but dedicated shop for archery enthusiasts, Jake, a seasoned craftsman, makes a case for paying close attention to something that might seem mundane but is anything but: the glue. For those building or repairing their arrows, Jake’s expertise boils down to a simple but critical choice between two adhesives: Goat Tuff GT Impact Adhesive and Boning Cool Flex Hot Melt. Each has its specific role, dictated by the needs of the archer and the intended use of the arrows. Goat Tuff GT Impact Adhesive For hunting arrows, where durability and permanence are paramount, Jake swears by Goat Tuff GT Impact Adhesive. This adhesive ensures that once the arrow’s insert is in place, it stays there — no adjustments, retesting, or second chances. The process, though straightforward, requires precision. First, Jake positions the insert slightly into the arrow shaft. Then, he applies a single line of adhesive to the insert, spinning it as he pushes it into place. This ensures an even coating. A quick wipe with a paper towel removes any excess glue, leaving a clean, finished product. The whole process takes seconds, and the result is a bond that won’t budge. Bohning Cool Flex Hot Melt While Goat Tuff is perfect for hunting arrows, Boning Cool Flex Hot Melt offers a more flexible solution, ideal for those who frequently test or adjust their setups. This adhesive’s standout feature is its low melting point, a critical consideration for carbon arrows, which can be damaged by excessive heat. With Cool Flex, you can remove or adjust the insert simply by warming it up, All it takes is a few seconds in boiling water. Jake demonstrated the technique with the same practiced ease. Using a butane torch, he heated an insert held firmly in a pair of pliers. You don’t need much heat. Once warmed, he applied an even layer of glue, slid the insert into the arrow shaft, and let it cool to room temperature. The remaining glue peeled off effortlessly, leaving a flawless finish. If you decide later to change the insert, just heat it again. It’s as simple as that. And because the glue has a low melting point, there’s no risk to the carbon shaft. The Right Tool for the Job For Jake, the choice between the two adhesives is all about the arrow’s purpose. Permanent hunting builds? Goat Tuff is the way to go. Versatile and adjustable setups? Bohning Cool Flex can’t be beaten. For archery enthusiasts looking to improve their craft, Jake’s lesson is a timely reminder: precision starts with the smallest details — even the adhesive you choose. At Fether Archery, that philosophy is evident in every arrow Jake builds.